Gas Appliance Installations in George — Stoves, Hobs & More

GasCraft George does more than gas geysers. we install gas stoves, built-in gas hobs and the gas lines that feed them across George and the Garden Route — every job done by a registered domestic LPG installer and signed off with a Certificate of Compliance.

Gas Appliances We Install

Most of our appliance work comes out of kitchens — a new stove delivered from the shop, a hob going into a renovation, or a family moving off electric cooking because they are tired of load shedding ruining supper. We handle the gas side of all of it: cylinders, regulator, line, connection, testing and certificate.

Gas Stove Installation

Freestanding gas stoves connected properly: correct regulator, correctly sized line, leak tested and certified. We connect stoves you bought yourself or supply the whole setup.

Gas stove installation

Gas Hob Installation

Built-in hobs fitted into the countertop opening, connected to the gas line and tested. Neat work, because unlike a geyser this one lives in the middle of your kitchen.

Gas hob installation

Gas Certificate of Compliance

Every appliance installation ends with a COC. We also inspect and certify existing installations for property sales, insurance and rental compliance.

Gas COC in George

New kitchens are the other big one. If a builder or kitchen company is fitting your cupboards, we come in at the right stage to run the gas line before the units close everything up, then return to connect the appliance once it is on site. Working alongside our gas geyser installations means one cylinder bank and one certificate can cover the whole house.

Gas hob and stove installation in a George kitchenMesh gas cylinder cage feeding a gas appliance installation at a home in George

Why Use a Registered Installer for Gas Appliances?

Because the law says so, and because your insurance depends on it. In South Africa a fixed gas appliance must be installed by a registered gas practitioner working to SANS 10087, and the installation must carry a Certificate of Compliance. Gas work is not a DIY job and it is not a handyman job.

It is a legal requirement

Only a registered installer may sign a gas COC. A connection done by an unregistered person cannot be certified, which means it will show up as a problem the day you sell or the day you claim.

Safety comes down to detail

Correct pipe sizing, the right regulator, approved hose within its date, secure cylinder placement and proper ventilation. Get one of those wrong and you have a slow leak in a closed kitchen.

Your insurer will ask

After a fire or a gas incident, the first question is who installed it and where is the certificate. An uncertified installation is the cheapest possible way to lose a claim.

Safe and compliant LP gas guidance
Google review
Work done neatly and on time
Google review
Professional service and good quality hardware
Google review

What’s Included in an Appliance Installation?

A complete job, not just a hose pushed onto a spigot. we quote the whole installation upfront so there are no surprises halfway through, and the certificate is handed over when the work is signed off.

  • Gas line and connection

    Copper line run and sized for the appliance, from the cylinder position to the stove or hob, with an isolation valve where it belongs so the appliance can be shut off on its own.

  • Regulator and cylinder setup

    The correct regulator for the appliance and cylinder bank, cylinders positioned and secured outside to the required clearances, and changeover fitted where two cylinders are used.

  • Leak and pressure testing

    The full installation is pressure tested and every joint checked before the appliance is used. We also confirm the flame picture and the flame-failure device on each burner.

  • Safety checks and COC

    Ventilation, clearances to combustibles, hose condition and appliance suitability all checked, then your Certificate of Compliance issued and explained before we leave.

Already have gas in the house and just need the paperwork brought up to date? That is a gas safety inspection or a compliance visit, not a new installation.

Gas Appliance Installation Questions

Yes. Any fixed gas appliance in a South African home — stove, hob, geyser or braai point — must be installed by a registered gas practitioner and signed off with a Certificate of Compliance. It is the document your insurer will ask for after an incident, and the one the conveyancer will ask for when you sell the house. We issue the COC as part of the installation, so you are not left chasing paperwork afterwards.

Get a quote for your stove or hob

Tell us what appliance you have and whether there is gas in the house already, and you will get a straight price. Call 071 551 2108 or send a WhatsApp with a photo of your kitchen and cylinder spot.

Gas Stove Installation

Freestanding stove connections in George and the Garden Route, including new gas lines where there is no gas in the house yet.

Read more

Gas Hob Installation

Built-in hobs connected, tested and certified, coordinated with your kitchen installer's countertop cutout.

Read more

Contact GasCraft George

Phone, WhatsApp and hours, plus the George and Garden Route suburbs we cover every week.

Get in touch
Call 071 551 2108WhatsApp